Digital Surface Profile Gauge

Digital Surface Profile acc. 0.002mm Range : 0-1000 microns
Acc. ±1 microns for checking sand blasting, shot blasting &grit blasting surface

Specification
Range : Metric/Imperial
Resolution : 2 microns (0.01 thou/mils)
Size
Height : 105mm (4.5”)
Width : 57mm (2.8”)
Depth : 27mm (1.3”)
Weight : 220g (4.5oz)

Pin hole Detectors

Indian made pinhole detector for checking any pinhole or defects on paint coated surface. with Sponge Prob
Range : 0-300 microns & 9 Volts
Pinhole Detector Heavy Duty 0-500 microns and Digital Range : 9,6.7 & 90 Volts. Combine

Holiday Detector U.K./ U.S.A.

Battery operated with voltage output of 0-15 KV & 0-30 KV. checks Bitumen or Epoxy on concrete eg. Storage tanks, water and sewage treatment facilities. Testing insulating coating on oil, gas & water pipelines. Provided rechargeable battery earth lead, high voltage probe, handle & lead band brush probe.

Testex Tapes USA

Elcometer U.K. 122 Testex Tapes provides a quick, easy to use low cost method of measuring rough surface profiles after shot or grit blasting. Used in conjuction with the tape gives peak to valley height. This method enables a replica of the anchor pattern profile to be produced, which can then be attached to a report, to provide a permanent record for future reference. Set of 50 replicas per roll.
Ranges Coarse E122...B Coarse 50 Microns, and X Coarse 37-100 microns Model E-122. Foil Thickness Gauge 1 micron Accuracy . For checking thickness of impressions for above.

Dial Type Micrometer Thickness Gauge

Acc. of 0.01mm , Range 0 to 10mm, Acc. 0.01mm for checking diameter thickness of small components and checking the thickness of sheets, papers, cardboards on any type of flat sheets.

Digital Thermometer

For checking temperature 0-1000º C with standard Probe.
for checking surface temperature. Also available thermemeter from -60 to 1200ºC The Digital Thermometer are Available long needle probes for checking Temperature liquids or Air

Swedish Standard Book (Sweden)

With various chart, colored actual photos & plates of rust checking & surface finish of Shot Blasting Sweden as per DIN Standard, ASTMBS Standard, ISO 8501-1-1988 & SS 055900. Finishes of surfaces checking SA2,2.5 & 3. SSPC - VIS - 1 Visual standards for Abrasive blast cleaning surfaces USA SSPC - VIS - 3 Visual standards for powder & Hand Tool cleaning steel. USA